精品国产三级a∨在线欧美-亚洲色图35p-亚洲 国产 韩国 欧美 在线-色偷偷88888欧美精品久久久-天天操综-自拍偷拍小视频

Different types of faucets have different installation details Today, the editor will be deep in our explanation

Installation details of kitchen faucet

1. Remove the entire accessories of the faucet, such as the dental tube, rubber basket, stainless steel basket, fixing nut, etc

2. Pass one of the inlet pipes through the faucet opening and through the counter top

3. Screw the inlet pipe that has already passed through into the inlet hole below the faucet and right it appropriately

4. Pass the entire removed dental tube through the inlet pipe that has been twisted into the faucet

5. Thread the second inlet pipe through the entire dental tube and scratch it into another inlet below the faucet, and right it appropriately

6. Align the dental tube with the bottom of the faucet and right it appropriately, adjust the orientation of the faucet, and then fix the accessories and right them properly

Editor&# 039; Friendly Tip: When installing kitchen faucets, it is essential to be able Due to the high frequency of use of kitchen faucets and their tension to loose when broken, locking nuts is critical

Installation details of bathroom basin faucet

1. Inventory the installation parts of the faucet First, we will put the copper bucket and a rubber pad into two hosts

2. Thread one end of the two pipes through the hole in the washbasin

3. First, thread the rubber pad into the host, and then thread the copper wire in

4. Screw the screw of the pipe onto the faucet

5. Screw the copper wire onto the faucet and place it in the hole of the polar basin to fix the faucet

Editor&# 039; Friendly Tip: When installing a faucet, it is necessary to choose a dedicated angle valve And the angle valve must be fixed to the cold and hot water pipes of the wall outlet If the inlet pipe is too long, it can be cut off, but do not bend it hard to 90 degrees or more In addition, when installing the base to drain water, please do not forget to purchase the small port of the fa UCET

Installation details of thermostatic faucet

1. Users with fine solid lumps in tap water are not suitable for using thermodynamic faucets

2. If the tap water contains powdery sedimentation or soft foreign objects, it may reduce the sensitivity of the thermal valve core and shorten the service life of the thermal faucet

3. Try to shorten the distance between the water heater and the faucet as many as possible, so that hot water can quickly reach the faucet

The cold and hot water supply pipes must not be installed incorrectly The hot water pipe must be on the left and the cold water pipe must be on the right

5. Before installing the constant temperature fault, it is necessary to Tidy up and clean the device site to avoid fine sand, stones, hard blocks damaging the rubber ring, thread, constant temperature valve core, and other parts of the fault

6. Please follow the instructions in the manual to install the device, and be particularly careful not to miss, lose, or damage any games or rubber rings

Article source: Kaiping faucet http://www.roqiship.com.cn/